The right hand heater channel where it meets the "A"
pillar. The heater duct at this point is socketed into each other (I did
not cut the duct at this point). The top of the heater channel on the
right of this photo has been removed to expose the heater duct inside.
top of page
top of page
The right hand heater channel where it meets the "A"
pillar. The "yellow" line indicates where I think the heater
duct should be. The duct turns at this point, to rise into the "A"
pillar.
top of page
top of page
Looking up into the right hand "A" pillar
after the bottom removed. This is the where the duct turns and rises into
the "A" pillar.
top of page
top of page
Now looking down into the right hand "A" from
the top.
top of page
top of page
Looking further down into the right hand "A"
pillar from the top.
top of page
top of page
The back of the bottom right hand door hinge. The piece
with the four threaded holes allows for adjustment of the hinge.
top of page
top of page
Inside the bottom of the "A" pillar. The heater
duct as it rises from the heater channel. The edge at the bottom right of
the photo is the inside of the front wheel well.
top of page
Section through the "A" pillar just above
the bottom of the windscreen.
top of page
top of page
Section through the "A" pillar just above
the bottom of the windscreen. Note the extra strengthening brace.
top of page
top of page
